Check Up Before Use; Please Keep In Mind; How To Set Special Modes - Coway BA16-CR/CE Mode D'emploi

CHECK UP BEFORE USE

Please keep in mind!

Connect the power.
Plug the power cord into the electrical outlet. The bidet only works normally when the
electricity is connected.
This product is for 220 V - 240 V~, 50 Hz only.
Make sure to connect the power plug to a grounded electrical outlet
Tips
(220 V - 240 V~, 50 Hz) dedicated to the product.
Open the main water supply valve.
Open the main water supply valve to activate the bidet.
Check whether the product is in power-saving mode.
- When seat sensor is locked and button is not pressed in power-saving mode.
• After 1 minute : The temperature of hot water and bidet seat is set to 'low'.
• After 30 minutes : Display panel lights go off and automatically converted to power-saving mode.
- In power-saving mode, the power indicator light goes off. Press any button to activate the product.
- When the power indicator light is still off, even the button on control panel is pressed, turn on the
product again. Then use the product.
Set on/off for special modes as you desire
You can set and use the specialized modes as you desire.Silent, power-saving and seat sensor lock modes are
provided.

How to set special modes

Press and hold the 'Stop' and 'Rear'
buttons simultaneously on the bidet
for 3 seconds. Set the special mode,
then the water pressure, water and
drying air temperature and seat
temperature indicators blink.
∗
If no button is pressed for 10 seconds, the
new setting is set automatically.
∗
In special modes, you can set 3 special modes in a row.
2. Power-saving mode
Press the
'Rear' button to set the silent
mode.
- To deactivate: The water
pressure indicator level 3 LED
goes off.
- To activate: The water pressure
indicator level 3 LED goes on.
∗
The power-saving mode is pre-set.
1. Silent mode
Press the 'Stop' button to set
the silent mode.
- To deactivate: The water
pressure indicator level 2 LED
goes off.
- To activate: The water pressure
indicator level 2 LED goes on.
∗
The silent mode is not pre-set.
3. Seat-sensor lock mode
Press the 'Front' button to set
the silent mode.
- To deactivate: The water
pressure indicator level
1 LED goes off.
- To activate: The water
pressure indicator level 1 LED goes on.
∗
The Seat-sensor lock mode is pre-set.