EGO ST1500E Mode D'emploi page 10

MOUNTING THE GUARD
WARNING:
Always wear gloves when mounting or
EN
replacing the guard. Take care of the blade on the guard
and protect your hand from cutting.
WARNING: Never operate the tool without the guard
firmly in place. The guard must always be on the tool
to protect the user! When the guard was fixed, never
attempted to remove or adjust the guard, if replace
needed, it shall be performed by a qualified service
technician!
Loosen and remove the two screws from the shaft base
(Fig. B), align the guard mounting holes with the assembly
holes and then lock the guard onto the shaft base with
the two screws, together with two spring washers (Fig. C).
Make sure the guard is fixed according to Fig. B & C, any
reverse fixing will cause great danger!
MOUNTING AND ADJUSTING THE FRONT-ASSIST
HANDLE
Push the front-assist handle onto the shaft (Fig. E), then
insert the clamping block into the handle slot (Fig. F), mount
the lock pole, and lock them with the wing nut (Fig. G). The
sequence is as Fig. D shown. Lastly, adjust the front-assist
handle position to make sure your front arm is straight
when using the trimmer ( Fig. H) and then lock the lever of
the lock pole (Fig. I )
Fig. D & H parts description see below:
D-1 Front-assist Handle
D-2 Lock Pole
D-3 Clamping Block
NOTICE:
The front-assist handle should be turned
upwards to point toward the top of the handle.
WARNING: Only fix the front-assist handle in front of
the soft sleeve on the shaft.
WARNING:
The tool can not be used without the
front-assist handle reliably fixed.
MOUNTING THE SHOULDER STRAP
Loose the bolt in the hook of the strap (Fig. J & K), attach the
hook onto the shaft and lock it with the bolt (Fig. L & M).
WARNING: Only fix the hook of the strap between the
housing and the soft sleeve on the shaft.
10
56 VOLT LITHIUM-ION CORDLESS STRING TRIMMER — ST1500E
OPERATION
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
shields. along with hearing protection. Failure to do so
could result in objects being thrown into your eyes and
other possible serious injuries.
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
the appropriate cutting line only for cutting grass and
similar material.
You may use this product for the purposes listed below:
Trimming: used for removing grass and weeds up against
walls, fences, trees and borders.
Cutting: used for cutting the grass that is difficult to reach
using a normal mower.
NOTICE:
purpose. Any other use, for example edge trimming, is
deemed to be a case of misuse.
D-4 Wing Nut
ATTACHING/DETACHING THE BATTERY PACK
H-1 Soft Sleeve
Fully charge before first use.
H-2 Warning Label
To Attach
Align the battery ribs with the mounting slots and press the
battery pack down until you hear a "click" (Fig. N).
To Detach
Depress the battery-release button and pull the battery pack
out as Fig. O shown.
HOLDING THE STRING TRIMMER
injury when operating this tool. Do not wear loose
clothing or jewelry. Wear eye and ear/hearing protection.
Wear heavy duty, long trousers, boots and gloves. Do not
wear short trousers, sandals or go barefoot.
Before operating, stand in the operating position and
check for eye protection, proper clothing, balanced footing,
straight arm, which holds the front-assist handle.
WARNING:
Do not allow familiarity with this product
WARNING: Always wear eye protection with side
WARNING:
Do not use any attachments or
WARNING:
Use your string trimmer equipped with
The tool is to be used only for its prescribed
WARNING:
Dress properly to reduce the risk of