Introduction - THERMOBILE TBD 18 Manuel De L'utilisateur

2

INTRODUCTION

2.1 Purpose
These electrical heaters have a axial fan
and are made for a flexible indoor
installation.
2.2 Principle of operation
The TBD 18 Heaters are mounted on a
frame for easy transportation.
Heating elemants are mounted in the
rotatable housing. The fan blows air accross
the heating elements.
The heater will switch off when
overheated. Overheating will occur when
the air flow is too low or when
environment temperature is to high. Once
it has cooled down, the heater will switch
on automatically (automatic reset).
2.3 Main components (Fig. 1)
A Rotatable pushbar
B Operating panel
C Identification plate
D Controlbox
E Heating Elements
F Airflow direction
G Wheel
H 5-pin-plug.
I Fan
2.4 Maximum thermostat
The heater a number of inbuilt maximum
thermostats that switch off the heater when
the maximum permissible temperature of
the hot air is exceeded.
2.5 Control thermostat
The heater has a control thermostat that
switches off the heater when the set
maximum ambient temperature is reached.
TBD 18
THERMOBILE INDUSTRIES BV
2.6
The heater has a control thermostat (D) and
3 rocker switches (A,B,C) for ventilation and
heating. The TBD18 has two 9kW switches.
If both swiches are turned on the heater
delivers a heat output of 18kW.
A
B
C
D
E
2.7
Allways check the heaters airflow direction
(fig.1 F). De fan has to blow the air accross
the heating elements.
2.8
It's easy to move the heater by using the
pushbar.
2.9
It is posible to aim the heater in any direction.
To do so; unlock the two black levers on the
side of the heater and rotate the housing.
Operating panel (Fig. 4)
Ventilation switch
0 = Fan off
1 = Fan on
Heating switch
0 = Additional heating off
1 = Additional
Second heating switch
0 = Additional heating off
1 = Additional
Control thermostat 20-70° c
(Room thermostat optional)
Airflow
Rotatable Push Bar (Fig.3 down)
To save space during transport or
storage of the heater it is possible to
fold in the push-bar. To do so; Lift the
handle and at the same time pull out
the black button on the side of the
heater.
Aim the heater (Fig.3 top )
heating on
heating on
12