Sony BKNW-25 Mode D'emploi page 34

Learn Operation
• If you connect another DV/DVCAM
camcorder to the BKNW-25, turn off
the BKNW-25 (the LEARN lamp
and the power lamp turn off), then
turn it on again. Afterwards, repeat
the procedures in "DV/DVCAM
camcorder settings" on page 7(GB)
and "Learn Operation" on page
12(GB).
• If you use a consumer VCR, tape
running speed synchronization and
edit start point linkage with the
recorder unit are not possible. This
is because consumer VCRs do not
have a video sync signal input
connector. It is thus impossible to
attain an frame error of ±0 during
editing.
14(GB)