Sony BKNW-25 Mode D'emploi page 24

Location of Parts
1 Power lamp
Lights up when the power is turned
on. Flashes while learning is executed
for the connected DV/DVCAM
camcorder and lights up again when
learning is completed.
2 POWER switch
Turns the power on or off.
1: The power is turned on.
g: The power is turned off.
3 525/625 switch
Selects the 525/60 mode or 625/50
mode.
4 DC IN (DC power input)
connector (XLR, 4-pin)
Connects to the DC output connector
of the AC power adaptor through the
DC power cable to supply AC power
to the BKNW-25.
5 SDI OUT (serial digital interface
output) connector (BNC)
Outputs SDI signals conforming to
SMPTE-259M/ITU-R BT.656-3.
Connects to the SDI input connector
of theVCR through the supplied SDI
cable.
......................................................................................................................................................................
i.LINK logo
i.LINK signifies the IEEE 1394-1995 standard and its extensions. i.LINK is a trademark of the Sony
corporation. The logo is printed on products that conform to i.LINK.
DV connector
DV connector is provided specifically to input and output (or only output) DV signals comforming to
i.LINK.
4(GB)
6 REMOTE (remote control)
connector (D-sub, 9-pin)
Connects to the VCR through the
supplied 9-pin remote control cable.
7 LEARN lamp
Lights up when the power is turned
on. Flashes while learning is executed
for the connected DV/DVCAM
camcorder and lights up again when
learning is completed.
8 LEARN button
Press to start a learning operation.
9 LANC l connector
(stereo-mini jack)
Connects to the LANC l connector
of the DV/DVCAM camcorder
through the supplied LANC cable.
0 DV IN (DV input) connector
Connects to the DV connector of the
DV/DVCAM camcorder through the
supplied DV cable.