Philips AVENT Premium SCD841 Mode D'emploi page 29

HOW TO USE / CONNECTING THE UNITS
Why do I need to keep
the baby unit and its
cord at least 1 meter/
3.5 feet away from my
baby?
What is the difference
between the various
user modes on the
parent unit: Video,
Audio, VOX and ECO?
How can I reset the
parent unit?
Perhaps temperature has exceeded the charging tolerance that could
potentially cut off the charging circuit as a safety protection mechanism. To
resume charging, move the charging station away from any heat sources
such as radiators, heat registers, stove or other appliances (including
amplifiers) that produce heat.
To avoid strangulation with the cord and for optimal sound detection,
always place the baby unit and its cord at least 1 meter / 3.5 feet away from
the baby.
See below list for an explanation on the available modes on your baby
monitor.
* Video mode: the screen and sound of the parent unit are always on.
* Audio mode: only audio will be activated. The display of the parent unit
switches off when AUDIO mode is activated. The link light shows that the
parent unit is still on and connected to the baby unit. The sound level lights
above the screen will light up green when sound from the baby unit is
heard. All normal correspondence with the baby unit is possible via the talk
back, lullaby, menu and sensitivity buttons.
* VOX mode: The display and sound of the parent unit switch off if there
is no sound detected for 20 seconds (or not enough sound above the
sensitivity setting). Both display and sound will be activated immediately
when your baby cries and the sensitivity threshold is passed. When the
sound drops below the sound threshold, the video will remain active for 20
seconds. When one of the control buttons is pressed (brightness or volume),
the device shall display video for roughly 5 seconds. Also the lullaby menu
is accessible.
* ECO mode: The display and sound of the parent unit switch off when no
sound is detected for 20 seconds. Eco Mode reduces power consumption
during quiet times while keeping you connected to your baby. In ECO
mode the ECO LED light is green and the device will operate on a different
connection modus. In ECO mode the parent unit uses the 2 seconds
ping mechanism to check the connection with the baby unit instead of a
continuous radio frequency connection. Therefore the Baby Unit will also
consume less energy in ECO mode.
You can reset the parent unit by simultaneously press the "power on/
off button" and the round "navigation down button" at the front of the
parent unit for about 1 second. The parent unit will switch off. In order to
turn the parent unit back on, press the "power on/off button". Specific user
information stored in the memory of the parent unit such as user mode,
brightness settings, volume, lullaby selection, zoom selection and vibration
settings will not be lost.
29
English