OPERATION INSTRUCTION OF THE CONTROL PANEL
1.3.16. Setpoint of the basic humidity level
Basic %RH level
40%
1.3.17. Mode of operation of the fireplace/booster switch
Switch type
Fireplace switch
1.3.18 Choosing cascade control for supply air temperature
Cascade adjust
Off
1.3.19 Choosing the basic humidity level
RH-level setting
automatic
1.3.20 Choosing post-heating for the unit
Radiator type
electric rad.
1.3.21 Choosing the interval for the maintenance reminder
Maintenance rem.
04
1.3.22 The hysteresis of the defrost function of the heat recovery cell
Hysteresis
03C
1.3.23 The stopping temperature of the supply air fan for the defrost function of the heat recovery cell
Input fan stop
05C
1.3.24 Preheating temperature for the defrost function of the heat recovery cell
Preheater
07C
1.3.25 Changing the setpoint for carbon dioxide adjustment
CO2-setting
0900 PPM
1.3.26 Choosing maximum fan speed
MAX fan speed
8
The desired setpoint is selected with the + and - buttons, unless automatic search of the
basic humidity level is used.
The mode of operation of the switch (either fireplace or booster switch) is selected with the
+ and - buttons.
NOTE! Fire and building regulations must be observed. (See page 4).
Without function!
Automatic or manual search of the basic humidity level.
The selection istdone with the + and - buttons.
Without function!
The intervall for the maintenance reminder is selected with the + and -
buttons. The maintenance reminder interval refers to months.
The hysteresis of the defrost function of the heat recovery cell is selected
with the + and buttons.
The stopping temperature of the supply air fan for the defrost function of the heat
recovery cell is chosen with the + and - buttons.
The preheating temperature for the defrost function of the heat recovery cell is chosen
with + and buttons.
The setpoint for CO
-adjustment is chosen with + and - buttons.
2
The desired maximum fan speed is selected with the + and buttons. Maximum fan
speed is on either with adjustments or permanently. See Section 1.3.6., Mode of
operation of the maximum speed setting.
16