Dräger Alcotest 3820 Notice D'utilisation page 7

the minutes in the same way: short press to change and long press to
confirm.
Measurement unit
A cursor pre-selects a measurement unit in the list. Press briefly on the
button to change the position of the cursor in order to select your
needed measurement unit. If the cursor selects the needed
measurement unit, please hold the button for approx. 2 seconds to
confirm.
After the setup wizard is finished, the display shows Welcome and
continues with READY for tests.
The Alcotest® 3820 is now adjusted to your settings and is ready for
breath tests.
Of course these and further settings can be adjusted in the device
menu (see section 4.6 on page 9).
4.3 Carrying out a breath sample
A new mouthpiece must be inserted for each person who provides
a breath test.
For hygiene reasons, hold the mouthpiece only on the grip zones.
Do not allow any high alcohol concentrations on the sensor, e.g.
by rinsing the mouth with a high proof alcohol shortly before the
measurement, as this will shorten the service life of the sensor.
Procedure
1. Remove the safety cap from the top of the device.
2. Insert a new mouthpiece (order no. 83 25 250) in the mouthpiece
receptacle (see section 3.1 on page 4).
For hygiene reasons, hold the mouthpiece only on the grip zones.
en
Use
7