Suitability For Use; Verification Procedure - Kong 225020020KK Notice D'utilisation Et D'entretien

SUITABILITY FOR USE:

The equipment should be used with a fall arrest system as specified in the data sheet (see standard EN363) to guarantee that the dynamic force exerted
on the user during the arrest of a fall is maxi 6 kN. A fall arrest harness (EN361) is the only body gripping device that may be used. It may be dangerous
to create one's own fall arrest system where each safety function can interfere with another safety function. Therefore, it is important to read the
recommendations on using each component in the system before use.

VERIFICATION PROCEDURE:

The recommended service life of the equipment is 10 years (in accordance with the annual examination by a competent person authorized by KONG),
but it may be increased or reduced according to use and/or the results of the annual inspections. The equipment should be inspected if there is any doubt,
or following a fall and at least annually, by the manufacturer or a competent person authorised by the manufacturer to check its strength and hence the
user's safety. The product's factsheet must be completed (in writing) after each check; the inspection date and the date of the next inspection must be
indicated on the factsheet, it is also advisable to specify the date of the next inspection on the product.
SERVICING AND STORAGE: (these instructions must be strictly observed)
During transportation, keep the equipment away from any cutting edges and in its packaging. Clean with water, wipe with a cloth and hang in a ventilated
room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may have got wet during use.
The device must be stored in a cool, dry and ventilated room, and in its packaging.
9