Subsequent Use - Philips TT3003 Mode D'emploi

1 Choose an area close to the intended
treatment area.
2 Press the on/off button to switch on
the appliance.
, Intensity light 1 goes on automatically to indicate
that the appliance is switched on at default
intensity 1.
3 Apply one flash at the lowest recommended
intensity for your skin type.
4 As long as it feels comfortable (not painful),
increase the setting by one level within the
recommended range for your skin type and
apply one flash for each setting. Do not apply
more than one flash on the same spot.
5 After the skin test, wait for 24 hours and
check your skin for any reaction. If the skin
shows reactions, choose the highest setting
that did not result in any skin reaction for

subsequent use.

subsequent use
1 Before every treatment, clean the body
attachment, light exit window and
metallic frame of Philips Lumea Plus for men.
2 Press the on/off button to switch on the appliance.
English
25