Procopi Wewa Rectangle Notice De Montage page 70

WEVA RECTANGULAR POOLS
> >
CAUTION
If while fi lling the
◗
pool you note that
the liner has been
pulled out of the
track, stop fi lling
before reengaging
it. You may have to
partially empty the
pool before you will
be able to rehang
the liner.
Repositioning of
◗
the liner by sliding
it along the track
is prohibited, this
could cause the liner
to tear. Release the
liner then reposition
it.
Refer to the
◗
additional
installation
instructions
provided with the
various fi ttings.
70
FILLING THE POOL & CUTTING THE LINER
> >
◗
Once the creases on the fl oor of the pool have been eliminated, continue fi lling until
the water level is 5 cm below the return fi ttings. At this point, mark the position of the
holes in the pool fi ttings through the liner and mount the various fl anges. Don't forget to
apply the second gasket to each fl ange before screwing it into position.
Figure 46
◗
Mark the holes for the screws. Apply the second fl ange. Screw into position (pozi
countersunk head screws TFZ M5x16 from the Pool Fitting skin). Tighten screws
alternately and moderately by hand.
Figure 49
◗
Proceed in the same way to fi t the skimmer fl anges.
Figure 51
Figure 47
Figure 50
◗ Next, using a Stanley knife, cut the liner inside the
fl anges.
Continue fi lling until the water level is 2/3 up the
mouth.
Figure 48