Procopi Wewa Rectangle Notice De Montage page 55

◗ Use a hammer and a clamp to gently tap the slats into position if necessary. Do not
strike the wooden slats directly, use the protective martyr blocks (supplied). Be careful
to ensure that each row of slats is fully engaged before starting with the next.
Figure 16
◗ Fit together the remaining slats taking care that the slats machined to receive the
pool fi ttings are in their correct positions.
The slats with the openings for the return fi ttings should be in the 6th row.
The slats machined to take the skimmers should be placed in rows 9 and 10 for the
3x6 pools and rows 10 and 11 for 4x8 and 5x10 pools.
The slat that will hold the vacuum point should be in row 8 of the 3x6 pool or row 9 of
the 4x8 and 5x10 pools.
Figure 17
5x80
5x100
◗
Cover the metallic posts with the
decorative profi les. The profi les
should be fl ush with the top of the
wooden wall.
◗
Screw them in place from the inside
of the pool as shown opposite. (SS
screw 5x80 bag O). The top of the
profi les will be screwed together
when the coping support fi ttings
are mounted on top of the posts
(fi g 22).
◗
Eliminate any splinters raised by
screwing.
◗
Should it be necessary to trim the
profi les to size (for example, if the
pool is partially in-ground) orient
the cut surface facing upwards.
◗
The 2 profi les do not meet, the
metallic post remains visible.
55