Procopi Wewa Rectangle Notice De Montage page 69

PIPE CONNECTIONS
◗ Connect the rigid descending pipes and the fi ltration group as illustrated in the
diagram below. The fi ltration kit supplied with your pool is sized for installation of
the fi ltration group 3.5 m from the pool, pipe and tube lengths are indicative. They
will need to be modifi ed as a function of your pool confi guration. Make sure that you
calculate and cut the various lengths as a function of the rolls of tubing provided.
Figure 45
Suction
return
POOL 3x6
1 = return length = +/- 3.6 m
2 = return Y length = +/- 0.7 m x2
3 = skimmer length = +/- 2.9 m x2
4 = pump fi lter length = +/- 0.7 m
◗
Once all the connections have been carried out, cut out the liner as described on
page 70 .
Check that all the valves are closed and fi ll the pool until the water level
◗
is 2/3 of the way up the skimmer mouth.
FILLING THE WATER CIRCUIT
◗ Open the various valves to fi ll the hydraulic circuit with water. Check for leaks.
◗ Before starting the pump (the pump should never be allowed to run 'dry') check that
the pre-fi lter has fi lled with water. If necessary, open the pre-fi lter and fi ll it and the
skimmer with water to facilitate priming of the pump.
◗ Turn the 6-way valve to Back Wash (to clean the fi lter before starting fi ltration.
See page 74).
◗
Start the pump and check for leaks again.
POOL 4x8
1 = return length = +/- 3.1 m
2 = return Y length = +/- 1.4 m x2
3 = skimmer length = +/- 3.1 m x2
4 = pump fi lter length = +/- 0.7 m
3
2
1
2
3
POOL 5x10
1 = return length = +/- 2.6 m
2 = return Y length = +/- 2.5 m x2
3 = skimmer length = +/- 3.3 m x2
4 = pump fi lter length = +/- 0.7 m
If the pool is to
installed in-ground,
check for leaks before
burying the lines and
connections.
4
CAUTION
69