Procopi Wewa Rectangle Notice De Montage page 66

WEVA RECTANGULAR POOLS
> >
CAUTION
◗ When assembling the
various connections use
Tefl on and check that
o-rings and seals, if any,
are in place.
ADVICE:
◗
When mounting the
rigid descending pipes,
the lower section can
be oriented to facilitate
subsequent assembly of
pipes.
66
MOUNTING THE RIGID DESCENDING PIPES
Figure 38
Union under the skimmer.
Figure 39
Return fi tting rigid
descending point.
Figure 37
Elbow on the return
fi tting
Figure 38'
◗
Wrap tefl on around the
2 threadings on the J unions and
screw them into position underneath
the skimmer.
◗
Screw the compression union heads
into position under the skimmers. Cut
the pipes at the mark corresponding
to the height of your pool. Chamfer
the cut slightly to facilitate insertion
of the pipe into the compression
union. Check that the tube is inserted
fully then tighten the green barrel
union taking care to ensure that the
connection is leaktight.
Rigid descending pipe
under the skimmer
◗
Screw the rigid descending fi ttings
C onto the return fi tting nozzle
elbows. Do not forget to check that
the o-ring is in position.
◗ Wrap Tefl on 4 or 5 times
around the elbows of the
rigid descending fi ttings C
(return fi ttings), screw them
onto the exterior outlets of
the nozzles, do not forget to
use the o-rings provided in the
pool fi ttings skin pack. Tighten
by hand to avoid crushing the
o-ring. Next, screw the upper
union of the rigid descending
pipes, C, onto the 2 return
fi tting elbows.