Continuity Test; Diode Test - CIMCO 11 1411 Notice D'emploi

- Now connect the two test probes to the object that you wish to measure. The measured value is
shown on the LCD display provided that the measured object does not have a high resistance or is
disconnected. Wait until the display stabilizes. This can take a few seconds for resistances >1 MOhm.
- After completing the measurement, remove the test leads from the measured object and turn off the
current clamp.

e) Continuity test
- Turn on the device and select the measurement range
to switch the measuring function. The
Press the button again to switch to the next measuring function.
- Insert the red test lead into the V socket (8) and the black test lead into the COM socket (7).
- An approximate value of <10 Ohm is recognized and you will hear a beep.
- As soon as < OL > (OL=Overload) appears on the LCD display, the measuring range has been
exceeded or the measuring circuit is broken.
- After completing the measurement, remove the test leads from the measured object and turn off the
current clamp.
f) Diode test
- Turn on the device and select the measurement range
(4) until the diode test symbol
next measuring function.
When measuring resistance, ensure that the measuring points that you touch with
the test probes are free from dirt, oil, solder etc. Such materials may distort the
measurement.
Make sure that all objects to be measured including circuit compon-
ents, circuits and component parts are disconnected and discharged.
Make sure that all objects to be measured including circuit compon-
ents, circuits and component parts are disconnected and discharged.
(J) is displayed on the LCD. Press the button again to switch to the
symbol for the continuity test (I) appears on the LCD display.
Ω . Press the SELECT/V.F.C button (4)
Ω . Press the SELECT/V.F.C button
43