Taking Measurements - CIMCO 11 1411 Notice D'emploi

Taking measurements

The measured values are displayed on the current clamp's LCD display (5). The measurement display on
the current clamp covers 2000 counts (count = smallest display value). The polarity will automatically be
displayed with the (-) sign for a negative reading.


38
Never exceed the maximum permitted input values. Do not touch
any circuits or circuit components if the circuit has voltages higher
than 33 V ACrms or 70 V DC. Fatal hazard!
The maximum permitted voltage in the measuring circuit against
ground potential must not exceed 600 V in CAT II and 300 V in CAT III.
Before measuring, check the connected test leads for damage, such
as cuts, tears and kinks. Damaged test leads must not be used! Fatal
hazard!
Do not touch the grip markings on the test prods when measuring.
Only the two test leads that are needed for measuring may be connec-
ted to the measuring device. For safety reasons, remove all unneces-
sary test leads from the measuring device when carrying out a current
measurement.
Measurements in circuits rated at >33 V/AC and >70 V/DC must
only be made by qualified and trained personnel who are familiar
with the relevant regulations and the associated hazards.
Pay attention to the necessary safety information, regulations and
protective measures for your own safety.
As soon as < OL > (OL=Overload) appears on the LCD display, the measuring
range has been exceeded.
There are protective caps on the angled connectors on the test leads included with
the product. Remove these before inserting the connectors into the measuring
device's sockets.