Turning On/Off / Selecting The Measuring Function; Measuring Current "A - CIMCO 11 1411 Notice D'emploi

a) Turning on/off / selecting the measuring function
The product is turned off when the rotary switch (3) is in the OFF position
(see figure 2). Turn off the product after you have finished using it.
Select the individual measuring functions using the rotary switch. The range
is selected automatically for some measuring functions. This means that the
appropriate measurement range will be chosen.
LCD display.

b) Measuring current "A"
The current is measured wirelessly via the current clamp (1). The sensors in the current clamp detect
the magnetic field that is surrounded by current-carrying conductors.

Measuring alternating currents (A
1. Turn on the product using the rotary switch (3) and select the 2A , 20A
ment range. The product is in the AC measurement range and < AC > and < A > appears on the
LCD display.
2. The display is automatically set to zero when the current clamp is closed and in the alternating current
measurement range.
3. Press the clamp opening lever (11) to open the current clamp. Surround the conductor that you
wish to measure and close the current clamp. Position the conductor in the middle between the two
triangular symbols on the clamp.
4. The measured current is shown on the LCD display. You will hear a beep sound if the measuring
range is exceeded (100 A).
5. After completing the measurement, remove the current clamp from the measured object and turn
off the device.
Important! Ensure that you have selected the correct
measuring function before each measurement.
Ensure that the conductor always passes through the centre of the current clamp
(pay attention to the arrow marks) and that the clamp is always closed.
Only ever surround one conductor with the current clamp.
(F) appears on the
)
Figure 2
or 100A measure-
39