Ego Power+ CS1800E Manuel De L'opérateur page 12

EN
PROBLEM
Chain saw does not cut
properly.
Chain drops off the
guide bar.
Bar and chain running
hot and smoking.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com egopowerplus.com for full terms and conditions of the EGO Warranty policy.
12
CORDLESS CHAIN SAW — CS1800E
CAUSE
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
◾
Dry or excessively stretched chain.
◾
Insufficient chain tension.
◾
Chain does not engage drive sprocket.
◾
Chain oil tank is empty.
◾
Debris in guide bar groove.
SOLUTION
◾
Loosen the quick chain-tension adjust knob
at least twice circles counterclockwise first
and then fully tighten it clockwise until the
chain is correctly tensioned.
◾
Sharpen the chain cutters, following
the section "HOW TO SHARPEN THE
CUTTERS".
◾
Reinstall the saw chain, following the
section "ASSEMBLING/REPLACING THE
BAR AND CHAIN".
◾
Replace the saw chain, following the
section "ASSEMBLING/REPLACING THE
BAR AND CHAIN".
◾
Check the oil level in the oil tank. Refill the
oil tank if necessary.
◾
Loosen the quick chain-tension adjust knob
at least twice circles counterclockwise first
and then fully tighten it clockwise until the
chain is correctly tensioned.
◾
Reinstall the chain, following the
section"ASSEMBLING/REPLACING THE
BAR AND CHAIN".ensuring that the drive
links on the chain are fully seated onto the
sprocket.
◾
Filling bar and chain lubricant.
◾
Clear the debris in the groove.