Carrier AquaSnap 30RB Manuel D'installation page 24

Unit
source circuit/ Compressor)
Water heat exchanger
inspection (Internal dirt and
clogging)
Inlet / Outlet water temperature
measurement
Circulation pump inspection
Automatic air purge valve
inspection
Expansion vessel
Heater assembly
Flow switch
Safety valve
operation)
Air heat exchanger inspection
(Dirt and clogging)
Fan inspection (Scratch,
damage)
As the compressors are hermetic, when an internal fault
occurs, the compressor must be replaced.
This must be done as detailed below:
recovery equipment
to damage the rest of the components.
If the water pump needs to be replaced, proceed as follows:
16 30RB
Annually Insulation measurement with a mega tester
Annually
Annually
must be found.
Annually
Temperature measurement: Temperature measurement
Annually
during an operation.
Annually
every 10 years: Charged).
Annually
Annually
Annually
terminal.
Annually
Annually
Annually Electronic voltage measurement.
Annually Visual inspection, Clear clogging
Annually
motor sound
nameplate through the service coupling located on the
low pressure side.
NOTE:
Periodic inspection details