Installation; Determine The Installation Type; Pre-Assembly Of Combination Ovens Prior To; Combination Oven Installation - Bosch 500 Série Mode D'emploi

Installation

Determine the Installation Type

This installation manual provides instructions for the
installation of single ovens, double ovens, and combination
ovens (a single oven combined with microwave or steam
oven).
Stand-alone single and double oven units require no
pre-assembly. Unless you are installing a combination
oven, skip over the combination oven pre-assembly
instructions and go directly to "Electrical Installation"
which applies to all ovens.
Pre-Assembly of Combination Ovens
Prior to Installation
Combination ovens (with microwave or steam oven)
require the units to be assembled together prior to installing
the combination unit into the wall cabinet.
Note: The single oven can be installed with a Steam Oven
or with a Microwave Oven. The installation procedure
differs between these. The parts contained in the square
tube parts box are common to both installations.Parts
Provided
Universal connector
bracket (2)
(in parts box on top of
oven)
Screws (16)
(in red bag, inside parts
box on top of oven)
Oven Mounting Screws
8 screws are included to
secure the oven trim to the
cabinet. The screws are
located in a small plastic
bag affixed to the literature
pack bag.
Combo service slide
assembly (2)*
* This part is
preassembled on the
oven to accomodate
attachment of a
microwave.
9000989321 Rev A

Combination Oven Installation

Installation with the Microwave Oven
Note: Do not place the oven into the wall cabinet until after
mounting the microwave on it using the universal connector
brackets.
1. The combo service slide assemblies are attached to
the oven spaced to accept the microwave.
2. Install both universal connector brackets using six of
the screws provided. Tighten screws securely, but do
not overtighten.
Note: The universal connector brackets are interchange-
able for the left and right sides of the oven. Be sure the
taller vertical edge of the bracket is positioned to the out-
side of the oven.
3. Install the decorative trim.
Position the decorative trim
piece so the flanges with
the holes in them face
away from the oven door.
Align the outer flanges with
the outside of the universal
brackets. Fasten with 1
screw each into the end
hole of the universal
bracket. Tighten screws
securely, but do not
overtighten.
English 5