Preparation; Before You Begin; Tools And Parts Needed; Parts Included - Bosch 500 Série Mode D'emploi

Preparation

Before You Begin

Tools and Parts Needed

• Phillips head screwdriver
• Star-head screwdriver (T20)
• Measuring tape
• Drill with bit (1/8")
• Gloves

Parts Included

• Phillips head screws (6)

General Information

Power Requirements
The outlet must be properly grounded in accordance with
all applicable codes.
For Best Installation
The oven can be difficult for two people to handle during
installation. It is recommended to have three or more
people available to assist with lifting the unit into place.
Removal of the bottom hinge oven door during installation
(to provide the necessary handholds and to significantly
reduce the unit weight) can be cumbersome unless the
detailed door removal instructions are followed carefully.
Note: Do not attempt to remove the side hinge door (some
models).
Please take time to read and follow the instructions
provided for an improved installation experience.
9000989321 Rev A

Checklist

Use this checklist to verify that you have completed each
step of the installation process. This can help you avoid
common mistakes.
___ 1. Before installing the oven, be sure to verify the
cabinet dimensions are correct for your unit and
the required electrical connections are present.
___ 2. Refer to the installation manual for content
regarding Safety, Cabinet Dimensions, Removing
Packaging, Electrical Installation, Testing the
Installation and Customer Service.
___ 3. Remove bottom hinged oven door(s) (not side
swing doors) to reduce the unit weight and to
provide access to handholds for lifting.
___ 4. Move the oven unit into place in front of the cabinet
opening, leaving the bottom packaging on the unit
to avoid damaging flooring.
___ 5 If installing a combination unit (oven and
microwave or oven and steam oven) complete the
assembly before installing the unit.
___ 6. Remove the torx head (T-20 size) screws holding
the unit to the base of the carton (using Star-head
screwdriver).
___ 7. Team lift the unit directly into the cabinet cutout
taking care not to pinch fingers or scratch hands or
arms. Make sure the electrical conduit reaches to
the connection point properly.
___ 8. Slide the unit all the way into place, making sure to
route the electrical conduit correctly.
___ 9. Fasten the oven unit to the cabinetry opening with
the screws supplied (using Philips screwdriver).
___ 10. Reinstall the oven door(s) removed in step 3
above.
___ 11. Consult the complete installation instructions and
follow the remainder of the procedures listed,
including performing an operation test.
___ 12. All product literature and accessories (may be
wrapped or boxed) with the oven.
___ 13. INSTALLER - Leave the literature pack and the
accessories with the customer.
English 3