Testing Operation; Before Calling Service; Data Plate - Bosch 500 Série Mode D'emploi

Testing Operation

1. Turn on power at the breaker.
2. Test the oven mode.
Select the BAKE mode. See the Use and Care Manual
for detailed operation instructions.
3. Verify that the oven light comes on and the oven begins
to preheat.
4. Test the door lock.
Set the SELF CLEAN mode. Confirm that the door
locks when the lock icon appears in the display.
5. If installing a double oven, test the second oven as
well.
6. If any of the tests do not result as explained above,
contact Bosch service for assistance. Otherwise, the
installation is complete at this time.

Before Calling Service

Seethe Use and Care Manual for troubleshooting
information. Refer to the Statement of Limited Warranty in
the Use and Care Manual.
To reach a service representative, see the contact
information at the front of the Use and Care Manual.
Please be prepared with the information printed on your
product data plate when calling.
English 16

Data Plate

The data plate shows the model and serial number. Refer
to the data plate on the appliance when requesting service.
The data plate location varies based on the oven model
and door hinge type.
Double Ovens, Bottom Hinge
Note: The rating plates (A) are at the left hand side of
the door trim of the lower oven cavity.
Single Ovens, Bottom Hinge
Note: The rating plates (A) are at the left hand side of
the door trim.
9000989321 Rev A