Liquid Vacuum Operation - Dura Vac VWMB508 0401 Manuel D'utilisation

OPERATING INSTRUCTIONS: DRY VACUUMING
5. Insert the locking end of the hose into the vacuum port and lock in place. Push the required
attachment onto the free end of the hose or extension. (fi g. 5)
6. Verify that the switch is in the 'O' (OFF) position before plugging the power cord into the outlet
(fi g. 6). Hang the vacuum onto the rack or use off the rack.
7. Turn the motor on by fl ipping the switch to the 'I' ON position. (fi g. 7) For remote control use,
set the power switch to remote control position "
'I' ON button on the remote control. (fi g. 8 & fi g. 9)
8. Once you have completed vacuuming, fl ip the switch to the 'O' OFF position or press the 'O'
OFF button on the remote control for at least one second.
O = OFF I = ON
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.

LIQUID VACUUM OPERATION

LIQUID VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION,
ENTITLED 'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN,
OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR
DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET.
MAKE SURE PLUG IS DISCONNECTED BEFORE CHANGING OR CLEANING FILTERS.
IMPORTANT! When vacuuming large quantities of liquids, we recommend that you remove the
vacuum from the mounting rack and put it on the fl oor. The vacuum can be heavy when full of
liquids and may be diffi cult to remove from the rack.
= Remote Control
9
" and turn the vacuum on by pressing the