Blowing Operation - Dura Vac VWMB508 0401 Manuel D'utilisation

This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH CSAZ94.3
BEFORE USING BLOWER.
CAUTION:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT
BE INHALED.
1. Verify that the switch is in the '0' (OFF) position. (fi g. 1)
2. Make sure the container is empty before using as a blower.
3. Lift the button on the blower fi lter door to the unlocked position and fl ip the blower fi lter door
open. (fi g. 2)
4. Remove hose from the vacuum port and insert the locking end of the hose into the blowing port
on the power head and lock into position. (fi g. 3)
5. Fit the desired extension wand and/or nozzle to the free end of the vacuum hose. (fi g. 4)
6. Before turning ON the vac, fi rmly hold loose end of the hose. Turn the motor on by fl ipping the
switch to the 'I' ON position (fi g. 5) or set the switch to the remote control setting and use the
remote control.

BLOWING OPERATION

11