Installation Places - Friedrich J Série Manuel D'installation

INSTALLATION PLACES

6
INSTALLATION PLACES
Indoor unit
- The place shall easily bear a load exceeding four times the indoor unit's weight.
- The place shall be able to inspect the unit as the figure.
- The place where the unit shall be leveled.
- The place shall allow easy water drainage.(Suitable dimension "H" is necessary to get a slope
to drain as figure.)
- The place shall easily connect with the outdoor unit.
- The place where the unit is not affected by an electrical noise.
- The place where air circulation in the room will be good .
- There should not be any heat source or steam near the unit
Top view
(unit: mm(inch))
Front view
(unit: mm(inch))
Inspection hole
600(23-5/8) X 600(23-5/8)
Control box
600(23-5/8)
Front
600(23-5/8)
20(25/32) or more