To Start Engine - benza BZS38 Manuel De L'utilisateur

WARNING: Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can
attract moisture which leads to separation and formation of acid sduring storage . Acidic gas can damage the
fuel system of an engine while in storage . To avoid engine problems, the fuel system should be emptied before
storage of 30 days or longer . Drain the gas tank, start the engine and let it run until the fuel lines and carburetor
are empty . Use fresh fuel next season . See storage instructions for additional information . Never use engine or
carburetor cleaner products in the fuel tank or permanent damage may occur .
CAUTION: Fill to bottom of gas tank filler neck . Do not overfill . Wipe off an y spilled oil or fuel . Do not store,
spill or use gasoline near an open flame .

TO START ENGINE

NOTE: Due to protective coatings on the engine, a small amount of smoke may be present during the initial use of the
product and should be considered normal .
1 . To start a cold engine, push in the switch knob, and then push primer (if equipped) three tim es before trying to start .
Use a firm push . This step is not usually necessary when starting an engine, which has alread y run for a few minutes .
2 . Move throttle control lever to fast position .
3 . Hold and pull starter handle quickly . Do not allow starter rope to snap back .
NOTE: In cooler weather it may be necessary to repeat priming steps (if prim er equipped) . In warmer weather over
priming may cause flooding and engine will not start . If you do flood engine, wait a few minutes before attempting to
start and do not repeat priming steps .
96 I
Operator's Manual