Installing/Removing The Reel Capsule - Grizzly MTS 43 AC E2 Mode D'emploi

4. Screw on the metal cutting blade (18)
anticlockwise
(35) and with the aid of the maintenance
key (see picture 2, no. 26).
pic. 5
15
Removing the metal cutting blade (pic-
ture 6):
5. To lock the axle, push the enclosed
metal pin (25) sideways into the hole
provided on the cutting head holder
(19) and on the bottom flange (33a).
pic. 6
26
33b
25
using the fixing nut
35
33b
18
33a
34
19
18
33a
19
6. Unscrew the fixing nut clockwise with the
aid of the maintenance key (26) and re-
move the top flange (33b) and the metal
cutting blade (18).
Installing/Removing the Reel
Capsule (Picture 7)
Dismantling the metal cutting blade
is described in the section on "In-
stalling/Removing the Metal Cutting
Blade".
Installing the protective cover/thread reel:
1. Screw the protective cover / reel capsule
(15) onto the protective cover / metal cut-
ting blade (20) using the 3 screws and
nuts (36) enclosed.
Installing the reel capsule:
2. Screw the reel capsule (16) anticlock-
wise onto the cutting head holder
by hand, as indicated in the diagram.
3. Remove the protective cap on the thread
cutter (14).
Removing the reel capsule:
4. Unscrew the reel capsule (16) clockwise
by hand. To make the work easier,
the cutting head holder (19) and bottom
flange (33a) can be locked using the en-
closed metal pin (see also picture 6).
pic. 7
36
14 15
GB
20 16
33a
121