Troubleshooting - ECOVACS ROBOTICS WINBOT8 Mode D'emploi

NO. Malfunction
Remote Control
1
does not work
Status Indicator
Light flashes BLUE
2
after WINBOT 8 is
placed on the glass
Possible Causes
WINBOT 8 is cleaning. When
WINBOT 8 is cleaning, only the
START/PAUSE Button works on
the Remote Control.
The Remote Control is not
paired with WINBOT 8.
WINBOT 8 arrives from the
factory paired with its Remote
Control. If the Remote Control
becomes un-paired or is
replaced, it can be re-paired.
WINBOT 8's Status Indicator
Light is glowing RED.
The Cleaning Pad is attached
incorrectly and is covering the
Fan or the Edge Detection
Sensors.
Edge Detection Sensor
malfunction.
Fan malfunction.
Glass is too dirty for WINBOT 8
to adhere properly.

6. Troubleshooting

Solutions
Pause WINBOT 8 by pressing
the START/PAUSE button on the
robot or Remote Control. Other
buttons on the Remote Control
will function when WINBOT 8 is
paused.
Power ON WINBOT 8. At the
same time, press and hold
button on WINBOT 8 and
button on the Remote Control.
Paring is complete when START/
PAUSE Button blinks RED, BLUE
and GREEN.
Reset WINBOT 8 by pressing the
RESET Button on the Remote
Control.
Remove the Cleaning Pad and
re-attach it making sure it is
placed exactly within its Velcro
area and does not cover the Fan
or Edge Detection Sensors.
A. Clean the Edge Detection
Sensors as described in Section 4.
B. If the problem persists, please
contact Customer Service.
A. Clean the Fan as described in
Section 4.
B. If the problem persists, please
contact Customer Service.
Clean a small area on the glass
before use and place WINBOT 8
there.
15
KO EN