Laser Automatique - Agatec A510S Mode D'emploi

ing from the use of the Product in conjunction with any sort of
ancillary or peripheral equipment and the manufacturer deter-
mines that there is no fault with the Product itself.
LIMITATION OF LIABILITY
The manufacturer also excludes any liability, whether based on
contract or tort (including negligence), for incidental, conse-
quential, indirect, special, or punitive damages of any kind, or
costs of procurement of substitute products by customer, or for
the loss of revenue or profits, loss of business, loss of informa-
tion or data, or other information or financial loss arising out of
or in consequence with the sale, installation, maintenance, use,
performance, failure, or interruption of this product, even if the
manufacturer or its distributors have been advised of the possi-

Laser Automatique

bility of such damages, and limits its liability to replacement,
repair, or refund of the purchase price paid, at the manufactur-
er's option. This limitation of liability for damages will not be
affected if any remedy provided herein shall fail of its essential
purpose.
NOTE: User is responsible for checking and maintaining cali-
bration. At a minimum, the laser should be checked before
beginning each job, when temperature changes greater than
50 degrees F (28 degrees C) have occurred, or after the unit
has taken a sharp jolt or been dropped.
DISCLAIMER
Should a court of jurisdiction not allow the entire exclusion or
limitation of implied warranties or the limitation of incidental or
consequential damages for certain products supplied to
Customers, or the limitation of liability for personal injury, such
implied warranties and such liabilities will be limited to the
duration of the applicable express warranty.
With this Limited Warranty, the manufacturer grants Customer
specific legal rights which do not restrict any statutory consumer
rights.
28