Specifications - Megger LCB2000/2 Guide De L'utilisateur

Operation - Additional Instructions for LCB2500/2 only
How to save a result
On completion and display of the measurement:
1. Press and hold the SAVE key. After about 1 second,
a bleep will be heard. For a (Loop) L-N test, a code,
as given in the following table is displayed.
L-N Live-Neutral Test
L-L Live-Live
(across Phases Test)
L-PE Live-Earth Test
The code is used to describe the circuit tested and can
be modified by the user. For all other tests, a circuit
number code is displayed, and you should proceed
directly to step 4.
2. The code may be changed by pressing the DOWN
key
3. The code may be accepted by pressing the SAVE
key, or aborted by pressing the EXIT key.
4. The circuit number is displayed as 2 digits, e.g. c01.
Note: Many different tests may be saved under the
same circuit number.
5. The circuit number may be changed by pressing the
UP and DOWN keys to display an appropriate
number. Hold the key down to step through the
circuit numbers.
6. The number can be accepted and the results saved
by pressing the SAVE key, or the procedure aborted
by pressing the EXIT key.
7. When the result is saved, the code Std is displayed
(accompanied by a long bleep) to confirm that the
data has been saved. The display of FULL indicates
that there is no more test storage.
Saving a Zd (distribution) result.
(L-PE and L-PE xtra ranges only).
This is very similar to saving a normal result, as above.
Steps 2 and 3 do not apply
On completion and display of the measurement:
1. Press and hold the SAVE key for about 1 second. A
long bleep sounds.
2. N/A
3. N/A
4. The circuit number is displayed.
5. Use the UP and DOWN buttons to reduce the circuit
number below 1 or increase it beyond 99.
The display shows 'Zd', which is the code for the
reference result.
Note: Only one Zd result can be stored for each
Distribution Board number. If such a result already
exists, a warning will be given. The 'Zd' code flashes
along with the triangle symbol, and the bleeper sounds.
The new result can still be saved if desired, but it will
overwrite the old one.
6. To accept and save the result, press the SAVE
button. To abort, press the EXIT button.
7. When the result is saved, the code Std is displayed
and a long bleep sounds. This confirms that the
data has been stored.
29