Bosch GLM 50 C Professional Notice Originale page 40

OBJ_BUCH-2450-005.book Page 40 Thursday, August 25, 2016 8:38 AM
40 | English
Deleting the Memory
To delete the content of the memory, press button 7 [Func] and select the memory
. Then briefly press the On/Off button 5 [
function
Simultaneously pressing the button 4 and the On/Off button 5 [
stored in the memory.
Adding/Subtracting Values
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement", see page 36.
Press the button 3 [+]. The calculated area and the symbol "+" will be
displayed.
2
50.039 m
Press the measuring button 2 [
0.0° 2
+93.406 m
Measure the area as described in section "Area Measurement", see
2
143.45 m
page 36. Once the second measurement is completed, the result of the
second area measurement is displayed below.To show the end result,
press the measurement button 2 [
Note: With a length measurement, the end result is displayed immediately.
To exit addition, press button 7 [Func].
Subtracting Values
To subtract values, press button 8 [–]. The subsequent steps are the same as for
"Adding Values".
Deleting Measured Values
Briefly pressing the On/Off button 5 [
measuring functions. Repeated brief pressing of the On/Off button 5 [
the measured values in reverse order.
Changing the Unit of Measure
Unit of measure "m" (metres) is set by default.
Switch the measuring tool on.
Press and hold button 7 [Func], to enter the "basic configurations" menu. Select "ft/m".
Press button 3 [+] or button 8 [–], to change the unit of measure.
Press the On/Off button 5 [
saved after you switch off the measuring tool.
1 609 92A 23J | (25.8.16)
] to delete the displayed value.
] to start another area measurement.
] once more.
] will delete the last measured value in all
] to exit the menu item. The selected setting remains
] deletes all values
] will delete
Bosch Power Tools