Black & Decker LHT2436 Mode D'emploi page 12

Problem
• Slow running, noisy or hot blades.
• Unit will not start.
• Battery won't charge.
For assistance, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACk &
DECkER help line at 1-800-544-6986.
TrOUBLeSHOOTINg
Possible Cause
• Dry, corroded blades.
• Blades or blade support bent.
• Bent or damaged teeth.
• Loose blade bolts.
• Battery not installed properly.
• Battery not charged.
• Lock off not fully operated.
• Battery not inserted into charger.
• Charger not plugged in.
• Surrounding air temperature too hot
or too cold.
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
• Lubricate blades.
• Straighten blade or blade support.
• Straighten teeth.
• Tighten blade bolts.
• Check battery installation.
• Check battery charging requirements.
• Check that lock off is fully pulled back
prior to moving main trigger.
• Insert battery into charger until green LED appears.
Charge up to 8 hours if battery totally drained.
• Plug charger into a working outlet. Refer to
"Important Charging Notes" for more details.
• Check current at receptacle by plugging in a
lamp or other appliance.
• Check to see if receptacle is connected to a
light switch which turns power off when you turn
out the lights.
• Move charger and tool to a surrounding air
temperature of above 40 degree F (4.5°C) or
below 105 degree F (+40.5°C).
See 'Tools-electric'
– yellow Pages –
for Service & Sales
12
Possible Solution