Technical Specifications - cecotec CONGA 3490 Mode D'emploi

The robot does not clean
effi ciently or dust leaks
from the robot.
The robot could not connect
to Wi-Fi
The robot did not carry out
the scheduled cleaning
The robot does not return to
the charging base after spot
cleaning or after changing
starting position.
The robot does not resume
cleaning
The robot is always offl ine
Connection between the
mobile phone and the robot
failed

10. TECHNICAL SPECIFICATIONS

Model: Conga 3490 Elite
Reference No.: 05431
100-240 V~50/60 Hz
Battery: 14.8 V, 3200 mAh
Frequency Bands: 2.412-2.472 GHz
Maximum Transmission Power: 16 dBm
Made in China | Designed in Spain
• The dust tank is full. Empty it and clear the high-effi ciency
fi lter if it is blocked.
• The high-effi ciency fi lter is blocked, clear it.
• The main brush is tangled with foreign matter, please clear
it up.
• The Wi-Fi signal is poor. Make sure the Wi-Fi signal is
correct.
• The Wi-Fi connection is unstable. Reset the router, check if
there are any App updates and try again.
• Check if the robot is in Night mode and switch mode. The
robot does not carry out scheduled cleaning cycles under
this mode.
• Make sure the robot is connected to the network, it will not
be able to carry out scheduled cleaning tasks without being
connected.
• The robot will map and calculate a new route after opera-
ting under spot cleaning or after having changed its starting
position.
• If the charging base is very far away from the robot, it will
not be able to charge back automatically. Put the robot back
on the charging base manually.
• Make sure the robot is not in Night mode, it will not resume
cleaning under this mode. It won't resume cleaning when it
is placed manually on the charging base.
• Make sure the robot is successfully connected to the ne-
twork and always in the range covered by the Wi-Fi signal.
• Make sure the robot and the charging base are in an area
with good Wi-Fi signal, reset the router and try connecting
them again.
ENGLISH
37