Overspeed - Dometic TEC60EV Notice D'utilisation

TEC60EV
Display message
Description
LOW POWER ENGINE
The inverter supply voltage has
dropped.

Overspeed

RPM too high
Start failed
Example: No fuel, cold tempera-
ture, spark plug to be replaced,
dirty air filter
GEN CAL
Message appears when the gen-
erator is started up; it shows the
calibration phase which takes
place before each start-up. The
generator does not supply any
voltage.
GEN WAIT
Message appears while you are
waiting for the generator to start
again.
GEN ON
The generator is operating
normally.
GEN OFF
GEN Stop
Wait Cooling
Inverter lost comm
EN
Generator behaviour
The generator stops.
The generator stops.
The generator is switched off.
The generator is running but
does not supply any voltage.
The generator is switched off.
Normal mode
The generator is idle and can be
started.
The generator is stopped.
The engine is running without
load to cool down the system.
The generator stops.
Operating the generator
Measures
Reduce the connected load and
start the generator again.
Press the button START/STOP to
restart the generator. If the prob-
lem persists, contact the manu-
facturer's branch office in your
country (see back page).
Press the start button to restart
the generator.
Wait a moment.
Wait until the message has disap-
peared then attempt ignition
again.
–
–
Wait a moment.
Wait a moment.
Check the system by referring to
the troubleshooting table.
If the problem persists, contact
the manufacturer's branch office
in your country (see back page).
17