Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connection device - device with pilot wire
-
The device should have a 220/230V 50/60Hz power supply.
-
The device's power supply must be directly connected to the main
supply after the circuit breaker without any intermediate switch.
-
The device's power cable must be connected to the main supply via a
device's power cable must be connected to the main supply via a
connection box. In damp areas, such as bathrooms and kitchens, the
connection box. In damp areas, such as bathrooms and kitchens, the
-
An Earth connection is prohibited. Do not connect the pilot wire
(black wire) to Earth.
-
Power must be directly connected to the grid after pole disconnection
device in accordance with the installation requirements.
-
If the power cable is damaged, it must only be replaced by an electrician.
-
If you are using the pilot wire and it is protected by a 30mA differential
(e.g.: bathroom use), the pilot wire's power supply must also be
protected on this differential.
Wiring diagram for the device
- Cut off the power supply and connect the wires as shown in the fol-
lowing diagram:
Panel heater cable
Phase = Brown
Neutral = Blue
Pilot Wire = Black
Commands
No current
Received
Oscilloscope
Ref/Neutral
Mode
COMFORT
obtained
Connection device - device with plug
WARNING: devices with plugs can not be installed on the French mar-
WARNING: devices with plugs can not be installed on the French mar
WARNING: devices with plugs can not be installed on the French mar
ket.
ELECTRICAL CONNEXION
Phase
Electricity
1
Neutral
grid
2
Complete
altermation
230 V
ECO
23
2 possible cases:
st
case: One heater
nd
case: Multiple heater
Negative
Half/altermation
– 115V
ANTI - FREEZE
Unpiloted device
Pilot wire not connected
To devices with reception box
or central programming
Positive
Half/altermation
+ 115V
STOP HEATING
LOAD SHEDDING
EN
Publicité
Table des Matières
