Basic Adjustments; Choosing The Gate Leaf Manoeuvre Speed; Choosing The Operating Cycle Of The Gate Leaf Manoeuvre - Nice ARIA200 Manuel D'installation Et D'utilisation

TABLE 1
Keys Paired command
T1 Step-by-Step (SbS)
T2 Pedestrian opening
T3 Open only
T4 Close only
T5 Not used in this application
Memorisation procedure
01. On the control unit (Fig. 19) press and hold key P1 for 3 seconds; when led L1 switches on, release the key.
02. Within 10 seconds from releasing it, press and hold for 3 seconds any button of the transmitter to be memorised.
If the memorisation procedure was successful, led P1 (on the control unit) will flash 3 times.
03. To memorise other transmitters, repeat step 02 within the next 10 seconds otherwise the memorisation phase will terminate automatically.

5.6 - BASIC ADJUSTMENTS

5.6.1 - Choosing the gate leaf manoeuvre speed

The opening and closing manoeuvre speed of the gate leaves can be either "slow" or "fast" (the type of selection chosen is visualised by the switching
on or off of led L2 on the control unit – Fig. 20):
led L2 off = the "slow" manoeuvre speed was selected.
led L2 on = the "fast" manoeuvre speed was selected.
Procedure for selecting the desired speed
01. Press and release key P2 several times until led L2 remains lit or switched off (Fig. 20).

5.6.2 - Choosing the operating cycle of the gate leaf manoeuvre

The type of "opening and closing" manoeuvre cycle of the gate leaves can be either "single cycle (semi-automatic)" or "complete cycle (automatic)"
(the type of selection chosen is visualised by the switching on or off of led L3 on the control unit – Fig. 21):
led L3 off = the "single cycle (semi-automatic)" manoeuvre cycle was selected (with the first command the gate opens and stays open until the next
command that causes it to close).
led L3 lit = the "complete cycle (automatic)" manoeuvre cycle was selected (with a single command the gate opens and re-closes automatically after
a set "pause time" – to adjust the latter see Par. 9.1.1).
Procedure for selecting the desired cycle
01. Press and release key P3 several times until led L3 remains lit or switched off (Fig. 21).
20
M M M M
T1
T3
FLASH BUS STOP SbS
LED
T5
T2
T4
21
M M
single cycle
19
M M FLASH BUS STOP SbS
complete cycle
English – 9