SFA SANICOMPACT COMFORT+ Mode D'emploi page 25

9.4 Assembly of the toilet bowl
• Adjust the distance between the inserts using the measurement
7.2).
• Tighten the double nuts according to the measurement
Y
• Once the connections have been made, adjust the inserts
the insert is positioned 75 mm from your cladding.
The hollows must point outwards.
F
10. FUNCTIONAL TEST AND COMMISSIONING
Important: It is necessary to run several functional tests before finishing.
• Plug in the device. Wait 20 seconds: start up the device.
• Fully open the water inlet in order to rinse properly.
• Start the normal cycle by pressing the dark grey part.
• Throw a few pieces of toilet paper in the bowl and repeat the flush cycle.
• Check that the connections do not leak.
Handbasin option:
• Let the tap of the handbasin run, the device should start automatically.
• Check that the connections do not leak.
• Replace the foam gasket
bowl support rods.
G
H
• Position a grub screw
• Tighten the grub screws with the supplied wrench
until the bowl is completely immobile.
• Close with the hole covers
Y
.
B so that the end of
and place the bowl on the
F
in the hole on each side.
G
.
M
EN
Y
(see fig.
H
25