SFA SANICOMPACT COMFORT+ Mode D'emploi page 23

8.2 Preparation and assembly of the cladding wall
F
• Place the foam gasket
rods.
• Trace the inner contour of the foam gasket on the cladding wall.
• Remove the foam gasket and cut the plasterboard according to the outline.
• Finish the complete installation (possibly tiling) of your cladding wall.
Note: If you are tiling your cladding wall, you must cut the tiles in the same way as the plaster-
board.
9. CONNECTION AND ASSEMBLY OF THE TOILET BOWL
• Reposition the foam gasket that will serve as a support between the bowl and the wall.
• Présenter la cuvette en appuis sur ses axes.
CAUTION, before making the various connections, check that the threaded rods
screwed into the frame and that the inserts
hollow facing outwards).
9.1 Connecting the discharge pipe
• Insert the hose into the discharge pipe.
K
on the cladding wall by positioning the 2 holes on the bowl support
F
B
• Place the plasterboard facing
the frame previously fixed to the
wall.
• Locate and drill the position
of the bowl support rods on the
plasterboard.
are positioned as shown in the diagram (with the
EN
A
are correctly
23