Waring Commercial MMB145 Directives D'utilisation page 7

as well as a 60-second countdown timer with Up and
Down arrows to set time. Always use hi speed for
crushing ice. The blender can operate in two modes:
timer mode and continuous mode.
5. For timer mode, press the Up or Down arrow to set the
desired time. The electronic timer will indicate run time
in 1-second intervals up to a maximum of 60 seconds.
Press and hold either Up or Down buttons for fast
scrolling. After the desired time is set, press hi or Lo
tostarttheblender.GreenLEDlightwillblinkduring
blending. The timer will count down to 0 in 1-second
intervals and blender will shut off. Pressing the Pulse
button or the stop button will override the timer and the
blender will stop regardless of time left on timer.
NoTE: if you want to increase or decrease time while timer is
counting down, press Up or Down arrows. Time will increase
or decrease in 1-second intervals.
6. if the stop button is pressed, the timer function will
turn off and the unit will return to continuous mode. To
reactivate timer, press Up or Down arrows. When using
the electronic timer again, the initial time will be the last
time set. Note: if unit has been unplugged, the timer will
default back to 5 seconds.
7. For continuous operation, press either the Lo or hi
button when timer is not lit. if the timer is lit and you
want to use continuous mode, press the stop button
and proceed. When finished blending, press stop. For
momentary operation, press the Pulse button. Motor
willrunonHispeeduntilthebuttonisreleased.Green
LED light will blink while in operation.
NoTE: This blender utilizes a slow start
beginning hi or Lo operation, the unit will start in a lower
speed for 3 seconds and then switch to the full selected
speed. Pulse utilizes a 1-second slow start
for a more even blending of ingredients in container.
feature. When
™
7
. This allows
™