Electrolux DMGL8321SW Prescriptions De Montage Et Mode D'emploi page 85

The front "Master" cooking zone can be used in combination
with the corresponding "Secondary" cooking zone at the
back
(to check which zones are equipped with this function, see the
illustrated part of this manual).
To activate the Bridge Function:
- simultaneously select the two cooking zones you want
to use
- the Display (2) of the "Secondary" cooking zone shows the
symbol " "
- using the Selection bar (3), it will be possible to set the
Level (Power) of exercise, which will be shown in the
Display (2) of the "Master" cooking zone
- to deactivate the Bridge Function simply repeat the same
activation procedure
Note: the Cooking Timer Zone, activated during the Bridge
Function, causes the automatic shut-down of both cooking
zones, as in this case they are considered a single combined
area.
USING THE EXTRACTOR FAN
Switch-on
Press (touch) briefly
continuing to press, all the available functions will become
visible for a few moments, e, after which only the main
ones will remain active; the others can be used, and will
be activated, subsequently, during use of the device.
IMPORTANT:
all the available functions will be illuminated with light
intensity, which will become more intense only when they
are activated.
Press again to turn off
Note: This function has priority over the others.
• Starting the extractor:
Touch (press) the Selection zone (12) to activate the
extractor
• Extraction speed (power):
The extractor is equipped with 3 levels of extraction speed
(power)
Touch and slide your fingers along the Selection bar (3):
to the right to increase the level of power;
to the left to decrease the level of power.
The power level set will be displayed in the
Selection/Display area (12)
Power Booster
The product has 2 additional power levels (above level 3)

Power Booster 1 : timed for 15 min.

Power Booster 2 : timed for 5 min.
after which the power returns to the previously set level.
Touch and slide with the fingers along the Selection bar (3)
(over level 3) and activate the Power Booster 1
The Power Booster level 1 is indicated in the Selection /
Display area (12) with the number "4" flashing
Touch and slide with the fingers along the Selection bar (3)
(over level 3) and activate the Power Booster 2
(1) hob/extractor;
The Power Booster level 2 is indicated in the Selection /
Display area (12) with the symbol" " flashing
Automatic operation
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the maximum cooking level used in the
cooking zone.
When the cooking zones are switched off, the hood adapts its
extraction speed, decreasing it gradually, to eliminate residual
vapours and odours.
To activate this function:
Press (14)
Repeat the operation to deactivate.
Note: if during automatic operation are selected from the
Selection bar (3) the speeds from 1 to 3, the automatic
operation is interrupted;
if, instead, the Power Boosters are selected, automatic
operation will resume at the end of the timing, while in the
meantime the symbol
Note: if the hob automatically shuts down with Automatic
mode active, the extractor fan will automatically turn off in a
gradual manner.
Filter saturation indicator
The hood indicates when filter maintenance is needed:
Carbon/ceramic odour filters
Grease filter
Note: this function is disabled by default (see how to
enable it in the paragraph "Activation filter saturation
indicator")
Reset filter saturation
After performing maintenance on the filters (greases and/or
carbon/ceramic), press and hold
restarting the indicator count.
Activation filter saturation indicator
This indicator is normally deactivated.
To activate it, proceed as follows:
• turn on the extractor hob via
• with the extraction motor and cooking zones off, press the
Selection zone (12)
• long press
alternately flashing in the Display (12)
F = carbon/ceramic odour filters
G = grease filter
Carbon/ceramic odour filters
• press on the Display (12) when the letter "F" appears
• press (13) – flashing light
85
remains flashing.
13) comes on
13) flashes
(13) turns off,
;
(11) until the letters "F" – "G" appear