Sony RM-IP10 Mode D'emploi page 7

mode for all RM-IP10s. When a camera is on-air, the CAMERA button on RM-IP10 lights in red. (This function will
be supported by version 2.0 or later).
For details of connection and settings, refer to the operating instructions of the IP remote controller.
Notes
• You cannot use the RS-232C and RS-422 connections when using the IP connection. When BRBK-IP10/IP7Z is
attached to the camera, the RS-232C/RS-422 connector does not work.
• When outputting an HD-SDI signal from BRBK-IP7Z, the signal delays about 4H in comparison with a YPb/Pr or
RGB signal that is output from the camera.
7
GB
System Configuration