Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
"DOWN" BUTTON
Press once the "DOWN" button, the temperature will
lower 1ºC.
"DISPLAY"
Display the actual temperature indoor.
SETTING THE TEMPERATURE
You can set the temperature as you desire by
pushing the UP or DOWN button. When you push
the two buttons for the first time, the LED readout
will show the original temperature set at previous
time.
The temperature that you desire to set will increase
1ºC if you push the UP button once, on the contrary
the temperature will decrease 1ºC if you push the
DOWN button once.
To view the "set" temperature. (anytime) press and
hold the up or down button for approximately 5
seconds, the "set" temperature will temporarily
"flash" in the LED display for 5 seconds.
The temperature setting can be adjusted from +5 ºC
to +18 ºC.
The temperature preset at the factory is +12 ºC.
DUAL ZONE
LIGHT
Control the interior light ON/OFF
RUN
When it's ON, the cooling system runs.
POWER
Control this appliance turn on/off. (press and hold
this button for approximately 3 seconds);
"Set Upper" Button
To set the temperature of the upper chamber.
"Set Lower" Button
To set the temperature of the lower chamber.
"Upper Chamber"
Display
the
actual
compartment.
temperature
in
upper
"Lower Chamber"
Display
the
compartment.
SETTING THE TEMPERATURE
When pressing "Set Upper" or " Set Lower"
button, the system will be entering the set up mode
in the upper or lower compartment automatically.
The LED will be flashing and displaying the setting
temperature.
Press once the button, the temperature will
decrease or increase 1 º C. When exceeding the
minimum value that can be established, it will jump
to
the
highest
automatically. After stopping pressing the button for
5 seconds, LED figure will stop flashing, then revert
back to display the temperature of the upper or
lower compartment.
After the unit is unplugged, the system will return to
acquiescence temperature, which is the factory
default setting. The acquiescence temperature as
below:
Upper compartment:+ 6 ºC
Lower compartment: +12 ºC
To view the "set" temperature. (anytime) press and
hold the up or down button for approximately 5
seconds, the "set" temperature will temporarily
"flash" in the LED display for 5 seconds.
Upper compartment: The temperature setting can be
adjusted from +5 ºC to +10 ºC.
Lower compartment: The temperature setting can be
adjusted from +10 ºC to +18 ºC.
Attention
If the unit is unplugged, power lost, or turned off, you
must wait 3 to 5 minutes before restart the unit. If
you need attempt to restart before this time delay,
the Wine cooler will not start. If first time use or if it
was out of use for a period of time, the temperature
will
vary
between
temperature. After running a period, the temperature
will be reverting back.
In order to reduce energy consumption, this wine
cabinet will automatically switch off the LED lights
after 10 minutes. If you want the LED light to remain
on continuously, press and hold the "LIGHT" button
for 5 seconds, the display will show "LP". After 4
seconds the display will revert back to normal and
the light will remain on until manually switched off. If
you
want to
(recommended), please press and hold the "LIGHT"
button for 5 second, the display will show "LF", after
4 seconds the display will revert back to normal, and
the light will automatically switch off after 10 minutes.
75
actual
temperature
adjustable
temperature
setting
and
LED
revert
back
and
save energy
in
lower
value
display
Publicité
Table des Matières
