Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DESIGN 2 – For fully integrated models
1.
Remove the glass door by unscrewing the eight
○
lock screws
and
,3
the glass door firmly after removing the screws
and place it on a padded surface to avoid the
risk of damage.
2.
Unscrew and transfer the door supporter
to the opposite side.
3.
Rotate the glass door 180°and refit the glass
door to the opposite side.
tighten it after the door is leveled.
DESIGN 3 – For tall models
1
2
1. Remove the bottom hinge
the four lock screws
door firmly after removing the screws.(Fig. 1)
2. Gently pull down to remove the glass door from
the right top hinge and place it on a padded
surface to avoid the risk of damage. Then
remove the right top hinge
3. Pop out the cover caps on the left side of
cabinet and use them to
on the right hand side.
4. Screw the alternative left top hinge
included in the fittings,
cabinet. (Fig. 4)
5. Unscrew and transfer door supporter
○
. Be careful to hold
,4
○
Then screw and
3
4
5
6
1 0
1
5
○
,1 by unscrewing
○
,2. Be careful to hold the
○
,9. (Fig. 4)
cover the screw holes
○
on the left hand side of
○
,10 to
the opposite side. At the same time remove the
stopper pin
designated position or unscrew and transfer the
hinge pin
designated position. (Fig. 5 & 3)
6. Unscrew and transfer the door adapter
and lock catch
position of glass door. (Fig. 2)
7. Rotate the door 180° and relocate the glass door
to the designated position.
bottom hinge on the left designated position and
tighten it. (Fig. 5)
8. Recheck and adjust the door alignment by
loosening the screws
adapter
door is levelled. (Fig. 5)
,2
DESIGN 4 – For double door models
9
1.
Remove the bottom hinge
the four screws
lower glass door
screws. And then gently pull down to remove
the lower glass door from the middle hinge and
place it on a padded surface to avoid the risk of
damage. (Fig. 1)
2.
Unscrew and transfer the door adapter
and
lower glass door. (Fig. 2)
3.
Remove the door adapter
the two lock screws
the upper glass door firmly after removing the
screws. And then gently pull down to remove
the upper glass door
,8 ,
and place it on a padded surface to avoid the
risk of damage. Then remove the right top hinge
○
,10. (Fig. 5 & 4)
67
○
,7 of bottom hinge to the opposite
○
of bottom hinge to the opposite
,7a
○
,4 to the top designated
○
,6and moving the door
○
,5. Tighten the screws
6
2
3
1
3
4
○
○
,2. Be careful to hold the
○
,3 firmly after removing the
○
,7 to the designated opposite position of
○
○
,13. Be careful to hold
○
,15 from the top hinge
○
,5
Then screw the
○
,6 after the
7
8
5
,1 by unscrewing
○
,4
,14 by unscrewing
Publicité
Table des Matières
