Dunavox DX-7.20BK/DP Manuel Utilisateur page 66

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DESIGN 1 –
1
2
Locate the handle
,1 over the fixing pins
the door and using the supplied allen key, tighten
the securing grub screws
DESIGN 2 –
1
2
3
1.
Remove the door gasket
wish to install the handle - you can see two
designated holes for handle installation.
2.
Install the handle
with two screws
provided.
3.
Replace the door gasket.
Note: All parts removed must be saved to
do the reinstallation of door.
REVERSING THE DOOR HINGE
It is possible to reverse the door on this appliance, if
required.
To do so, follow the steps below:
3
,3 of
,2 to fix the handle.
4
5
on the side you
,1
tightly as shown above
,4
and flat washers
,3
DESIGN 1 – For built-under models
1.
Remove the ventilation grille
adjustable ventilation grille
the screws
NOTE: For some models without adjustable
ventilation grille, the step is not needed.
2.
Remove the bottom hinge
the four lock screws
the glass door firmly after removing the screws.
(Fig. 2)
3.
Gently pull down to remove the glass door
from the right top hinge and place it on a
padded surface to avoid the risk of damage.
Then remove the right top hinge
4.
Unscrew and transfer hinge pin
door stopper
opposite side. (Fig. 3)
5.
Pop out the cover caps on the left side of
cabinet and use them to
on the right hand side.
,2
6.
Screw the alternative left top hinge
included in the fittings,
cabinet. (Fig. 4)
7.
Unscrew and transfer the holes cover
and lock catch
glass door. (Only for models with lock on the
ventilation grille) (Fig. 5)
8.
Rotate the door 180° (No need for models with
lock on the door) and relocate the door to the
designated position. Then screw the bottom
hinge assembly on the left designated position
and tighten it after the door is leveled.
9.
Transfer the handles & plugs to the opposite
positions and then reassembly the ventilation
grilles if need.
66
by unscrewing
,1
. (Fig. 1)
,3 &
,4
,5 by unscrewing
,6. Be careful to hold
,8of the bottom hinge to the
cover the screw holes
on the left hand side of
,13 to the opposite side of
and the
,2
,9. (Fig. 4)
,7 and/or
,11 ,
,12

Publicité

Table des Matières
loading

Table des Matières