Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The
symbol on the product or its packaging
indicates that this product is not to be handled
as normal household waste but is to be taken to
a recycling collection point for electrical and
electronic goods. By correctly disposing of this
product you are contributing to the protection of
the environment and to the health of your fellow
human beings. Improper disposal endangers
health and the environment. Further information
about the recycling of the product may be
obtained from your town hall, refuse collection
department or the store where you purchased
the product.
PRODUCT FEATURES
Built-in or Free-standing installation with single,
dual or three temperature zone, depending on
your model.
Continuously variable electronic temperature
control with digital display and touchpad input.
Temperature can be set from 5° to 18°C or 22°C
(40° to 64°F or 72°F) for either compartment and
can be displayed in either Fahrenheit or Celsius.
Can be set to the long time storage maturing
temperature or a specific serving temperature
for red/white/sparkling wines.
Cooling and Heating (for particular items only) to
maintain the perfect storaging and/or service
condition.
Dynamic compressor type cooling to ensure
interior air circulation with even distribution of
temperature and humidity.
Soft LED Interior Light with ON/OFF switch –
Function mode and Showcase mode.
Open-door and malfunction warning system (for
particular items only)
Sabbath mode will allow the lights to remain off
during
certain
religious
particular models only).
Temperature memory function - If power is
interrupted (power surge, breaker switch, etc.)
and then powered up again, the unit will operate
with the last temperature set-point.
Automatic
defrosting
evaporation.
Reversible tempered double/triple pane glass
door protects your wine from UV light and
creates
an
attractive
condensation and low noise.
Black coated matte steel outer frame and black
plastic interior liner offer lifetime performance
and stability. The black liner prevents excessive
light from damaging the maturity process.
Full glass or seamless stainless steel-framed
glass door with stainless steel handle.
Beech shelves allow for maximum convenience
and flexibility to accommodate various size
bottles(except DX-7.20 models).
Environmentally friendly refrigerant and foaming
materials.
Security lock system with keys (for particular
items only).
observances
(for
with
defrost
water
display
with
few
Passive humidity control system (Humidity Box).
Active charcoal air filter (for particular items only).
NOTE: Features and specifications are subject to
change without notice.
INSTALLATION
BEFORE USING YOUR APPLIANCE
Remove all exterior and interior packing. Clean
the interior surface with lukewarm water using a
soft cloth. The unit may have residual odors at
first, they will disappear as the unit cools.
Before connecting the appliance to the power
source, let it stand upright for at least 24 hours.
This will reduce the possibility of a malfunction in
the cooling system caused by handling during
transportation. During this time we recommend
that you leave the door open to clear any
residual odors.
The door on this appliance can be opened from
either the left or the right side. The unit is
delivered with the door opening on the left side.
Should you wish to open the door from the right,
follow the instructions 'Reversing the door
hinge'Install the handle on the door if necessary.
INSTALLATION OF YOUR APPLIANCE
The appliances are designed to be built-in or
recessed or free standing installation.
WARNING: Do not store or install the appliance
outdoors. The unit is for indoor use only.
WARNING: Do no install the appliance in the
laundry. Avoid locating the unit in damp areas.
Place your appliance on a floor that is strong
enough to support it when it is fully loaded.
Remove the transport legs before installation.
Fix installation legs (packed to your user manual)
if you need to level the unit only.
For freestanding installation, 100mm of space
between the back and sides of the unit are
suggested,
circulation
condenser for energy saving. Even for built-in
installation, it is a must to keep 5mm space on
each side and at the top to ensure proper
service access and ventilation. Take care that
the air vent at the front of the appliance must
never be covered or blocked in any way.
Locate the unit away from direct sunlight and
sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and
heat
sources
consumption.
temperatures may also cause the unit not to
perform properly.
64
which
allows
the
to
cool
the
compressor
may
increase
Extreme
cold
proper
air
and
electrical
ambient
Publicité
Table des Matières
