Dunavox DX-7.20BK/DP Manuel Utilisateur page 71

TEMPERATURE DISPLAY
During normal operation, the temperature display on
the control panel shows the temperature inside the
appliance. The temperature display will flash if
- A different temperature is being set,
- The temperature in the zone deviates by more
than 5°C from the set temperature.
The temperature display flashing ensures that the
temperature can not rise or fall un-noticed and
impair the wine.
TEMPERATURE MEMORY FUNCTION
In the event of a power interruption
breaker switch, etc.), the unit remembers the
previous temperature settings. When the power is
recovered, the cabinet temperature will go back the
same setting temperature as before the power
interruption.
TEMPERATURE ALARM
An alarm will sound if the temperature in one of the
zones rises or falls outside the temperature range.
The relevant temperature display will flash at the
same time.
The temperature the appliance is set at determines
the temperature the appliance recognises as being
too warm or too cool.
The alarm will sound and the temperature display
will flash:
- When you switch the appliance on, if the
temperature inside the appliance is very different
from the temperature set.
- When there has been a lengthy interruption to
the power supply.
- When too many items have been
unit at one time.
- When the door is not closed tightly.
DOOR ALARM
If the door has been left open for more than 60
seconds, the alarm will sound.
Once the set temperature has been reached in the
appliance, the alarm stops and the relevant
temperature display stops flashing. However, if the
noise disturbs you, you can switch the alarm off
before this if you wish by pressing the POWER key
once. The alarm will stop. The relevant temperature
display continues to flash until the set temperature
has been reached. The display then lights up
constantly, and the alarm system is fully active again.
INTERIOR LIGHT
The interior light makes it easy to view your wine
labels and enhances the display of your collection.
Touching the LIGHT mark toggles between 2 modes
(power surge,
put into the
71
of operation for the internal lights: functional (default)
mode and showcase mode. If you are in functional
(default) mode, the lights will turn on only when the
door is open. If you are in showcase mode, the lights
will be on whether or not the door is open.
The unit is equipped with a LED light fitting system.
To change the LED light fitting pls contact the
service department.
NOTE: Please use only the original LED light fittings
provided by the manufacturer.
BOTTLE RACKS AND STORAGE
WARNING: Do not pull out more than one loaded
shelf at a time as this may cause the unit to tilt
forward. Some shelves are designed to store more
than 1 layer of bottles. Such shelves are not allowed
to slide if more than 1 layer of bottles loaded on
them.
WARNING: Do not try to slide the shelves outwards
beyond the fixed position to prevent the bottles from
falling.
WARNING: To prevent damaging the door gasket,
make sure the door is fully open when pulling
shelves out of the compartment.
All the wine racks slide out for easy access, except
for the bottom shelf. For easy access to the bottles
stored, pull the rack out gently until it stops. The
shelves are designed with an emergency stop to
prevent them being removed too far when loaded.
Many bottles may differ in size and dimensions. As
such the actual number of bottles you may be able
to store may vary.
Bottle capacities are approximate maximums when
storing traditional Bordeaux 750 ML bottles and
include bulk storage.
You may load your wine bottles in single row or by
stacking while taking note of the following - if you do
not have enough bottles to fill your wine cellar, it is
better to distribute the load throughout the wine
cellar so as to avoid "all on top" or "all below" type
loads.
- Do remove or relocate adjustable wooden
racks to accommodate larger type of bottles or
increase the capacity of the cellar by stacking
the bottles up when necessary. (See removing
shelves)
- Keep small gaps between the walls and the
bottles to allow air circulation. Like an
underground cellar air circulation is important
to prevent mould and promote a better
homogeneous temperature.
- Do not overload your wine cellar to facilitate air
circulation.
- Lay the bottles flat.
- Avoid obstructing the internal fans (located
inside on the back panel of the unit).