Product Information; Declaration Of Conformity; Personal Safety - Hilti DSH 700 Mode D'emploi Original

1.5

Product information

products are designed for professional users and only trained, authorized personnel are permitted
to operate, service and maintain the products. This personnel must be specifically informed about the
possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Abrasive-disc cut-off saw
Generation:
Serial no.:
Abrasive-disc cut-off saw
Generation:
Serial no.:
1.6

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration issued by the certification department can be found at the end of
this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2 Safety
2.1

Personal safety

▶ Use the right tool for the job. Do not use the tool for purposes for which it was not intended. Use it only
as directed and when in technically faultless condition.
▶ Never tamper with or modify the tool in any way.
▶ Only persons who are familiar with it, who have been trained on how to use it safely and who understand
the resulting hazards are permitted to use the tool. The tool is not intended for use by children.
▶ Stay alert, watch what you are doing and use common sense when operating the tool. Do not use the
tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention
while operating the tool can result in serious personal injury.
▶ The user and persons in the vicinity must wear ANSI Z87.1-approved protective goggles, a hard hat, ear
protectors, protective gloves, protective footwear and light respiratory protection while the tool is in use.
▶ Always hold the tool firmly with both hands on the grips provided. Keep the grips dry, clean and free
from oil and grease.
▶ Never use the tool without the guard (hood). Adjust the guard to the correct position. The guard must be
securely attached and positioned for maximum safety, so that the smallest possible part of the cutting
disc is exposed to the operator. Make sure that sparks created during use do not present a hazard. The
guard helps to protect the operator from broken disc fragments, inadvertent contact with the cutting disc
and uncontrolled flying sparks.
▶ Before using the tool, or if an obstacle is contacted while the tool is in use, check the guard immediately
for possible damage. Replace the guard immediately if it is damaged or broken.
▶ Do not touch rotating parts – risk of injury!
▶ Maintain a firm footing and balance at all times. This will allow you to control the tool better, even in
unexpected situations, for example, in the event of experiencing kickback or rotational forces. Avoid
unusual postures.
▶ Wear suitable work clothes. Do not wear jewelry or loose clothing. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewelry or long hair can be snagged by moving parts.
▶ If the tool or the cutting disc has been dropped or has fallen, check the tool and the cutting disc for
damage. Change the cutting disc if necessary.
▶ Switch the tool off before adjusting the guard or changing the cutting disc.
2122989
*2122989*
Printed: 17.05.2018 | Doc-Nr: PUB / 5252090 / 000 / 07
DSH 700 | DSH 900
01
DSH 700-X | DSH 900-X
02
English 3