Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• After installation, ensure that the mechanism is properly adjusted and that the protection system and any manual releases function correctly
• Permanently fix the label concerning the manual release adjacent to its actuating member
TABLE OF CONTENTS
GENERAL PRECAUTIONS:
SAFETY - INSTALLATION - USE
5.1 - Integrated safety stop device
6 - SCRAPPING THE PRODUCT
1
PRODUCT DESCRIPTION AND INTENDED USE
This product belongs to the HDFI range of gear motors, designed to
automate non-balanced doors: section doors, quick doors and indus-
trial shutters.
Models HDFI 30-120 KU, HDFI 45-95 KU, HDFI 95-95 KU and
HDFI 180-95 KU are equipped with electronic end-of-travel device
ENAS002, which is an absolute value encoder.
The positions are set using the control unit.
2
LIMITS OF USE
Before proceeding with installation, check the suitability of the product:
consult the technical data on product performance (chapter 8 - Techni-
cal specifications).
2 - English
1
2
2
3
3
EC DECLARATION OF CONFORMITY
3
3
5
5
5
5
5
6
WARNING! - All uses other than the intended use, or use in
conditions other than those described in this manual should be
considered improper and forbidden!
WARNING! - The gear motor model should be selected based
on the total weight the motor must lift, the winding reel, the
thickness of the wall/sheet and the friction this creates against
the structure of the door/shutter.
6
6
7
8
9
Publicité
Chapitres
Table des Matières
