Symbols; General Warnings And Cautions - ResMed Stellar 100 Manuel D'utilisation

10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in
metres (m) can be determined using the equation applicable to the frequency of the transmitter, where P is the
maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.

Symbols

Follow instructions for use;
IP31 Device is protected against solid foreign objects of 0.1" (2.5 mm) diameter and greater
and vertically falling water drops;
of equipment;
port;
- 20 °C
- 4 °F
Maximum humidity;
number;
Keep away from sunlight;
Environmental information This device must be disposed of in accordance with the laws
and regulations of the country in which disposal occurs.
For further information regarding product disposal, please contact your local ResMed office
or your specialist distributor, or visit our website at www.resmed.com.
Dispose of used air filters and air tubings according to the directives in your country.

General warnings and cautions

WARNINGS
A warning alerts you to possible injury.
•
Read the entire manual before using the device.
•
This device should only be used with air tubing and accessories recommended by
ResMed or the prescribing clinician. Use of incorrect air tubing and accessories may
affect the functioning of this device.
•
The device and the accessories are to be used for the specified intended use only.
•
The device must only be used with masks (and connectors
ResMed, or by a clinician or respiratory therapist. A mask should not be used unless
the device is turned on and operating properly. The vent hole or holes associated with
the mask should never be blocked.
Explanation: The Stellar is intended to be used with special masks (or connectors
which have vent holes to allow continuous flow of air out of the mask. When the device
is turned on and functioning properly, new air from the device flushes the exhaled air out
through the mask vent holes. However, when the device is not operating, insufficient
fresh air will be provided through the mask, and the exhaled air may be rebreathed.
Rebreathing of exhaled air for longer than several minutes can, in some circumstances,
lead to suffocation. This applies to most Positive Airway Pressure devices.
1 Ports may be incorporated into the mask or in connectors that are near the mask.
30
3.69
11.70
Connection for oxygen supply; max 30 l/min (max 30 L/min);
+ 60 °C
+ 140 °F
Temperature limitation for storage and transport;
Keep dry;
Serial number;
1.11
3.50
Class II equipment;
Caution; Standby or preparatory state for a part
Manufacturer;
Batch code; Do not re-use;
Do not use if package is damaged;
2.21
7 .0
Type BF equipment;
Data
Handle with care;
Upside; Catalogue
Use by date;
LATEX
Latex-free
1
) recommended by
1
)