Installation Hints - dosatron D 25 F Manuel D'utilisation

Masquer les pouces Voir aussi pour D 25 F:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
ASSEMBLING THE DOSATRON (cont...)
the DOSatRON is delivered with a suction tube (cut it to the needed length)
enabling its use with a large capacity concentrate container.
the tube must be fitted with its strainer and weights.
the instructions for fitting the tube are to be found in the specific chapter.
NOtE : the maximum suction height is 4 meters (13 vertical feet).
Fit the tube, equipped with its strainer and its weight, and immerse it in the
solution to be injected.
IMPORTANT ! - Do not put the suction tube strainer on the bottom of the
stock solution container. The strainer must be suspended at least 10 cm
[4"] above the bottom of the tank to avoid sucking up the insoluble par-
ticles that may damage the injection assembly (Fig.2).
- Do not put the strainer on the ground.
WHAT YOU SHOULD DO
Fig. 2
WHAT YOU MUST NOT DO
Under no circumstance should the solution level be above the water
inlet of the DOSATRON (to avoid siphoning situations).
©
DOSatRON INtERNatIONaL / 36
Fig. 3
NO !

INSTALLATION HINTS

the DOSatRON can be connected to
the main water line directly (Fig. 4) ;
on a by-pass (Fig. 5), recommended.
If your flow rate is above the opera-
ting limits of the DOSatRON, see
EXCESSIVE FLOW.
to prolong the working life of the
DOSatRON it is advisable to install a
filter (ex.: 300 mesh - 60 microns depen-
ding on your water quality) upstream.
this is imperative if the water contains
impurities or particles, especially if the
water comes from a well.
Valve
Filter
Fig. 4
EXCESSIVE FLOW (as an indication)
If your DOSatRON clicks more than 40 times, that is 20 cycles in 15 seconds*,
you are close to the maximum flow limit. If you need more flow, you must
install a DOSatRON with a higher capacity of flow.
*D 25 RE 10 = 30 times, 15 cycles
©
©
DOSatRON INtERNatIONaL / 37
DOSatRON INtERNatIONaL / 37
A filter is recommended and requi-
red for the warranty to be valid.
Installing
the
DOSatRON
on
a bypass enables clean water to
be supplied without operating the
DOSatRON and the DOSatRON to
be easily dismantled.
When connecting an
installation to the public
water supply, you must res-
pect the rules and regulations
in force in the country.
Check
valve
Valve
Fig. 5
Filter

Publicité

Table des Matières
loading

Table des Matières